View source for TiLDA MKe/Full Specification

The following hardware has been included on the badge.

* [http://www.atmel.com/products/microcontrollers/arm/sam3x.aspx Atmel ATSAM3X8E]
** This is the same chip as the [http://arduino.cc/en/Main/ArduinoBoardDue Arduino Due] and gives us the base platform for the badge
** 32bit ARM Cortex M3 * 84MHz
** 512KBytes Flash RAM
** 96KBytes of SRAM
* A 128x64 pixel monochrome LCD display
* [http://shop.ciseco.co.uk/srf-wireless-rf-radio-surface-mount/ Ciseco SRF Radio]
** 868Mhz RF Transceiver
** Simple UART interface
** Low power sleep mode
* [http://www.invensense.com/mems/gyro/mpu6050.html MPU-6050] 3-axis Accelerometer and 3-axis gyro
** I2C interface
** Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
** Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
** Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronisation and gesture detection
* PMIC & LiPo
* Joystick, 4 way with click
* Buttons
* RGB LEDs
* IR Transmitter
* Arduino Headers
* Pads for wearable tech