TiLDA MKe/Full Specification

From EMF Badge
Revision as of 16:20, 1 May 2015 by Thinkl33t (talk | contribs) (Created page with "==Full Specification== The following hardware has been included on the badge. * [http://www.atmel.com/products/microcontrollers/arm/sam3x.aspx Atmel ATSAM3X8E] ** This is th...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Full Specification

The following hardware has been included on the badge.

  • Atmel ATSAM3X8E
    • This is the same chip as the Arduino Due and gives us the base platform for the badge
    • 32bit ARM Cortex M3 * 84MHz
    • 512KBytes Flash RAM
    • 96KBytes of SRAM
  • A 128x64 pixel monochrome LCD display
  • Ciseco SRF Radio
    • 868Mhz RF Transceiver
    • Simple UART interface
    • Low power sleep mode
  • MPU-6050 3-axis Accelerometer and 3-axis gyro
    • I2C interface
    • Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
    • Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
    • Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronisation and gesture detection
  • PMIC & LiPo
  • Joystick, 4 way with click
  • Buttons
  • RGB LEDs
  • IR Transmitter
  • Arduino Headers
  • Pads for wearable tech